[Wing] Fw: Wing digest, Vol 1 #144 - 1 msg

[Bob_Cutting at toyota.ca]

Hi Ernest,  I am at Boundary Bay Airport just outside Vancouver BC.    Vans
is partly correct, you need to make  a new plate .063 for the bottom of the
carb,  but the problem is you cannot fit the box with the filter in place,
the nose wheel leg is in the way...(great if you have a 9)    The solution
is to cut of the rear half of the box as a separate piece, fitted on with
nutplates . I will take some digital pictures for you..   As far as the
baffles are concerned,  the mounting holes in the heads are in a different
location, and the diameter of the cylinder barrels is different, you would
probably be better of getting patterns from an 0-235.   These are the only
2 ares that gave me problems,  the baffles being the easiest.   I will kep
you posted.
Bob.