[Wing] Bracket on F-649

[George McNutt]

  -----Original Message-----
  From: wing-admin at vansairforce.org [mailto:wing-admin at vansairforce.org]On
Behalf Of Tom and Marilyn Law
  Sent: Thursday, September 26, 2002 4:59 PM
  To: wing at vansairforce.org
  Subject: [Wing] Bracket on F-649


  Hi,
       I may be having a case of "Blueprint Vision Overload"  (it would not
be the first time..... nor the second ...)  but print page #37 in the upper
right corner shows a end view of the F-649 removable flap mechanism cover
with some type of bracket or support attached to the inside of it about 1/2
way up.  Possibly it is something to separate the rudder cable from the flap
mechanism should the cable sag down??  Where in the prints does it show what
it is and how it is attached?     Tom Law  RV6A in Whitehorse, Yukon


  [George McNutt]

  Sharp eyes Tom, I missed that when building mine and did not install
anything where the bracket is shown. No problems with rudder cable. You
could always install a bracket later during final assembly when you see the
relationship between the flap assembly and rudder cable, put it on your "to
do" list.

  Those removable panels are a trickey fit. Make sure they are easy to
remove/install for servicing, flap adjustment etc. and to avoid future
frustration put the instructions (this corner first etc) on the back side of
the panel.

  George McNutt
  6A - flying.


-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://retrix.com/pipermail/wing/attachments/20020926/c917f504/attachment-0001.htm